St. George, Utah · Washington County
Fireplaces Built for St. George
At 2,536 feet with winter lows around 28°F, St. George has its own answer—and a family-owned shop nearby that installs it.
Why it matters in St. George
What Shapes a Hearth Here
St. George sits at 2,536 feet, low and warm by Utah standards, with winter lows around 28°F. Heat output matters less here than it does up north, which changes the whole calculation: a fireplace in St. George is usually bought for the room it makes rather than the furnace it replaces. Smaller units, linear shapes, and electric all make more sense here than they do at 6,000 feet.
Natural gas reaches essentially all of St. George, so most homes already have gas plumbed to a furnace or a range and extending a line to a fireplace is a straightforward add rather than a project of its own.
Zip codes we cover here: 84770 · 84790 · 84791. Territory in Utah runs by zip rather than city line, so those five digits are what actually decide which shop you're routed to.
Permits in St. George
Inside city limits the permit goes through the St. George building division; unincorporated Washington County goes through the county. Gas piping has to be done by a licensed gas-fitter. Your shop pulls the permit, coordinates the hookup, and handles the final inspection as one job.
Elevation
Near the bottom of our range—this is red rock country.
The shops
Who Serves St. George
Every one of them is family owned, installs its own work, and has a showroom you can walk into.
- Installs its own work
- Family owned
- Showroom you can walk into
- Mon–Fri 9am–5pm
- Installs its own work
- Family owned
- Showroom you can walk into
- Mon–Fri 10am–4pm
- Installs its own work
- Family owned
- Showroom you can walk into
Which one is your home?
Every Project Starts From One of These Five
Choose the right fuel for your home
What to Burn in St. George
How it works
Here's How to Find the Perfect Fireplace
- 01
Browse the Products
Answer a few questions about your room and see the units that actually fit it.
Browse fireplaces → - 02
Find Your Local Dealer
Enter your zip code and meet the shop that serves your neighborhood. One shop, not a bidding pile.
Find your dealer → - 03
Book an Appointment
Showroom visit or in-home. They handle the permit, the venting, and the install.
Book an appointment →
Before you call anyone
Questions From St. George
Can I run a fireplace in St. George on a red air day?
Yes. Action-day restrictions apply to solid fuel, and they bite hardest on the valley floor. If burning on the worst air days matters to you, that's a reason to lean gas or electric—and a reason to ask the shop directly rather than guessing.
Do I need a permit to install a fireplace in St. George?
Yes. Inside city limits it goes through the city building division; unincorporated Washington County goes through the county. Gas piping has to be done by a licensed gas-fitter. Every shop in this network pulls the permit, coordinates the gas hookup with the utility, and handles the final inspection as part of the job, so you're not managing separate trades.
Is natural gas available in St. George?
For practical purposes, yes—gas reaches essentially all of St. George, and most homes already have it running to a furnace or a range. Propane becomes relevant mainly for properties above the gas footprint, and most units can be configured for either fuel; the installer sets the correct orifice and regulator.
What will it cost in St. George?
For a typical project covering the unit, the venting, and a straightforward install, plan on roughly $4,700 to $6,600. Once finish work, a gas line, and electrical are in, a complete installation more often lands between $6,000 and $14,400. Make sure any number you're given covers the whole scope—unit, vent, gas line, electrical, finish work, and the permit.
Will it still work when the power goes out in St. George?
Most modern gas units keep running: pilot-on-demand ignition carries a battery backup that takes over automatically, and some brands' pilots generate their own current and need no power at all. Wood needs nothing. Electric needs the grid. Say out loud that outage heat is a priority and the shop will steer you accordingly.
Nearby
Other Areas in St. George Area
Find Your St. George Shop
Enter your zip code and meet the showroom that covers your street.